There are further requirements for the clearance between live parts and surrounding fences or vehicles driving through the substation. All relevant clearances in high voltage substations can be calculated easily and quickly using primtech.
Insufficient Phase to Phase clearance
In order to calculate clearances in a substation according to IEC 60071-2, there are two fundamental prerequisites that have to be fulfilled:
a) A 3D CAD-model of the substation.
b) Information about each geometry - specifying if it is a live or earthed/grounded part, an insulator or a special object e.g. fence or street.
Both requirements are completely fulfilled by primtech.
On the basis of the intelligent primtech 3D-models, the Phase Checker classifies all geometries into the following:
- live parts
- earth parts
All live parts are then classified, through automatic phase tracking, into phase 1, 2 or 3. As a side note, you can also use the phase checker to see if all electrical conductors are correctly connected.
Top view diagram of live phases
in an Air Insulated Substation
All the required minimum distances throughout the whole substation can now be automatically determined based on the 3D model processed by the Phase Checker. The parts of the substation to be checked for sufficient clearance by be chosen individually and flexibly. primtech then visually highlight the areas which do not fulfill the minimum distance requirements to each other. The following clearances can be calculates:
- Phase to Phase
- Phase to Earth
- Phases to Streets
- Phases to Fences
- Phases to Ground Level
- Insulators to Ground Level
Warning for insufficient Phase to Earth clearance (left)
Phase to Fence clearance (right)
In addition to the clearance calculation, primtech can check the 3D model for collisions.